HomeEquipmentKnowledgeCompany中文
Home / Knowledge / Process Basics

Heat Input Is Not Magic: Tuning Parameters for Penetration Without Burn-Through

Process Basics · Updated November 2026

The most common line when talking parameters with owners: "I hear it's all tuning — dark art stuff." Not magic at all — heat input is one division problem. Read this and you'll at least follow what a technician is saying.

1. The Formula Is One Line

Heat input (J/mm) = welding current (A) × arc voltage (V) ÷ travel speed (mm/s)

The numerator is heat delivered; the denominator is how fast you move. More heat, slower travel — each millimeter of weld "eats" more heat; the reverse, less. That's all.

2. Too Much or Too Little — Each Has Its Own Disease

Heat inputTypical signsConsequences
Too highOverheated, sagging poolCoarse grains, lower toughness; burn-through on thin wall; undercut
RightStable pool, even fish-scale rippleSound penetration, good bead, properties met
Too low"Dead" pool, poor wettingLack of penetration and fusion — fails NDT

So parameters aren't "the bigger the easier" — they must ride the narrow path between "penetrating" and "not burning through." The thinner the wall, the narrower the path and the tighter the tuning.

3. Why Automatic Welding Is Born with the Advantage

All three variables in the formula — current, voltage, speed — are set values on an automatic machine; every joint's heat input is the same number. Manual? The current knob drifts, speed lives in the wrist — heat input on the same seam naturally fluctuates.

That explains two familiar phenomena:

Practical advice: confirm parameters on a test plate or first joint at every size change, then archive the parameter sheet. On a few-hundred-joint project, that "first article + parameter archive" routine becomes your quality record.

FAQ

How is heat input calculated?

Heat input = current × voltage ÷ travel speed (J/mm) — the intensity of heat the pool receives, governing penetration, structure and properties.

Consequences of too high or too low?

Too high: coarse grains, lower toughness, burn-through, undercut. Too low: no penetration, lack of fusion, NDT failure.

Why is automatic welding's heat input more controllable?

Current, voltage and speed are machine-locked — every joint identical. Manual speed depends on feel, so heat input fluctuates naturally.

For more automatic welding process knowledge, visit Tianjin Yixin's official website.