HomeEquipmentKnowledgeCompany中文
Home / Knowledge / Maintenance

Daily Maintenance in Three Items: Wire Feeding, Contact Tips, Shielding Gas

Maintenance · Updated November 2026

Whether a machine keeps "welding steady" is half maintenance. No thick manual to memorize — watch three things daily: wire feeding, contact tips, shielding gas. Manage these three and 80% of small faults simply never happen.

1. Wire Feeding: If the Arc Flickers, Check the Wire Path First

Wire travels from spool to torch through drive rolls, a straightener and a liner. Any snag makes feeding surge and stall, the arc brightens and dims with it, and the ripple falls apart. Check three points:

2. Contact Tips: Least Glamorous, Most Capable of Ruining a Weld

Once the tip bore wears oversize, the contact point drifts and stick-out changes — arc position and pool condition go wrong at once. Wear is gradual; crews often say "the bead got worse these two days," chase parameters for half a day, and the real answer is the tip needs changing. Tips cost pennies — replace on running hours; don't wait until a joint is scrapped.

3. Gas Lines: Where Most Porosity Begins

Check three things on the gas path: joints for leaks (soap water is the most direct test), flowmeter accuracy, cylinder residual pressure. A small leak weakens the pool's gas blanket by a degree — and wind makes it worse. Nine out of ten porosity problems trace back to the gas line.

4. The Checklist: Per Shift, Per Week, Per Month

IntervalItems
Every shiftVisual inspection, gas joint leak check, clean spatter from contact tip
WeeklyDrive roll cleaning and check, liner blow-out, travel mechanism lubrication and cleaning
MonthlyConsumables inventory and replacement, cables and connectors tightened, whole-machine dust removal
Well-maintained machines break down less, hold parameters better, and keep higher resale value. Flip it around: when a machine suddenly "goes unstable," run these three checks before calling for service — most "faults" are just overdue maintenance.

FAQ

Bead suddenly worse — check what first?

The contact tip. Worn oversize means drifting arc and changed stick-out. It's a consumable — replace on running hours.

Signs of unstable wire feeding?

Flickering arc, more spatter, irregular ripple. Causes: worn drive rolls, poor straightening, liner resistance — clean per shift, replace rolls on schedule.

Porosity — where to look first?

The gas line: leak check, flowmeter calibration, cylinder pressure — then site wind protection. Every leak weakens shielding and invites porosity.

For more automatic welding process knowledge, visit Tianjin Yixin's official website.